Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Particle Diameter (dp) Constraints

Please login with a confirmed email address before reporting spam

When running a laminar flow and particle tracing for fluid flow through a needle, how would one add constraints to the particle size so that if a particle is a certain size, it won't pass through the needle?


0 Replies Last Post Apr 19, 2021, 7:36 p.m. EDT
COMSOL Moderator

Hello Alexis Enstrom

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.