Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Electromechanics simulation

Please login with a confirmed email address before reporting spam

Hi

I am working on electromechanical simulation of fixed-fixed beam. Shall I use same moving mesh method as per application available for electrostatically actuated cantilever to fixed-fixed beam?

In this module when parametric sweep of pull-in voltage for 2 micro meter deflection is applied, actual deflection shows 0.67 micro meter. Why 2 micrometer deflection not shown for applied bias? Is it correct way of interpreting pull-in voltage?

pls suggest...


0 Replies Last Post Oct 19, 2018, 7:06 a.m. EDT
COMSOL Moderator

Hello Surendra Waghmare

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.