Cannot resolve for " center of coil" error .

Please login with a confirmed email address before reporting spam

I am designing solenoid for charged particle tracing but I couldn't resolve for the error "cannot determine centre of the coil" under magnetic fields node.


1 Reply Last Post 01/04/2020, 08:07 GMT-4
Lars Dammann COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 3 months ago 01/04/2020, 08:07 GMT-4

Hi, do you have your Coil set to "Circular"? Did you select a circular edge in the "Coil Geometry" subnode of the Coil node? If that does not work, perhaps try the "Numeric" coil type. See these example models that may be helpful: https://www.comsol.com/model/magnetic-field-of-a-helmholtz-coil-15 and https://www.comsol.com/model/multi-turn-coil-above-an-asymmetric-conductor-plate-13777

Hi, do you have your Coil set to "Circular"? Did you select a circular edge in the "Coil Geometry" subnode of the Coil node? If that does not work, perhaps try the "Numeric" coil type. See these example models that may be helpful: https://www.comsol.com/model/magnetic-field-of-a-helmholtz-coil-15 and https://www.comsol.com/model/multi-turn-coil-above-an-asymmetric-conductor-plate-13777

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.