Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Condition Based Boundary Source
Posted 27/05/2020, 07:32 GMT-4 Mechanical, Heat Transfer & Phase Change, Structural Mechanics & Thermal Stresses 1 Reply
Please login with a confirmed email address before reporting spam
I was trying to develop a process model in Heat transfer module (2d). I have curve boundary and a heat source has to be applied on certain portion of the curve . I selected the complete curve in Boundary heat source , and gave such an expression in the heat source tab
(x<50)*(x>10)*Heat source value
I was assuming that the source will be applied only in the portion where x>10 and x<50. But observed that the source is acting on the complete curve. Tried the same with if condition, and the output is same.
Can anyone please consider Thanks a lot, Stay safe