Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem on Analytic function

I want to define analytic function E, which is a function to time, t, but when I want to plot out E(t), there is always a error, which is attached. Who can help me figure out what is the problem? t isrange(0,0.0625,30). thanks


4 Replies Last Post 04/02/2013, 01:03 GMT-05:00
Posted: 5 years ago 03/02/2013, 13:13 GMT-05:00
Hi

I do not believe "e" is defined like that (perhaps "e_const" not even sure), have you checked the help function for the build in functions?
I expect to see something like exp(-t) tat should work

--
Good luck
Ivar
Hi I do not believe "e" is defined like that (perhaps "e_const" not even sure), have you checked the help function for the build in functions? I expect to see something like exp(-t) tat should work -- Good luck Ivar

Posted: 5 years ago 03/02/2013, 20:29 GMT-05:00
Thanks for your reply.
when I change it to -2*t, it still doesn't work, so what is the problem for the "invalid lower bound error" enclosed in the attachment.
Thanks for your reply. when I change it to -2*t, it still doesn't work, so what is the problem for the "invalid lower bound error" enclosed in the attachment.

Posted: 5 years ago 03/02/2013, 20:29 GMT-05:00
Thanks for your reply.
when I change it to -2*t, it still doesn't work, so what is the problem for the "invalid lower bound error" enclosed in the attachment.
Thanks for your reply. when I change it to -2*t, it still doesn't work, so what is the problem for the "invalid lower bound error" enclosed in the attachment.

Posted: 5 years ago 04/02/2013, 01:03 GMT-05:00
Hi

for the plot further down on the definition node tabs you need to define the plot limits of "t", I expect then something is wrong there, check the doc

--
Good luck
Ivar
Hi for the plot further down on the definition node tabs you need to define the plot limits of "t", I expect then something is wrong there, check the doc -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.