Note: This discussion is about an older version of the COMSOL Multiphysics^{®} software. The information provided may be out of date.

**Discussion Closed** This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

## Forced Convection over a plane plate

Posted 02/10/2013, 10:19 GMT-04:00 Fluid, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD) Version 4.3a 7 Replies

Hi guys,

I calculated the cooling of a plate by a turbulent forced convection analytically. Now I want to check my results with COMSOL but I have some troubles, maybe someone would be so kind and help me.

My plate is 0.075 m long, to keep the plate at +4 °C i need a power of ~130 W. The cooling fluid is air and has a temperature of -30 °C with a "inflow" - velocity of 45 m/s.

I tried to model my plate in COMSOL with a rectangle ( 0.075 m x 0.005 m ), this plate is in the upper right corner of an "larger" rectangle. The inlet is on the left. The material of my plate is copper.

My first problem is how to fit the power, because for my analytic approach i have just a surface (~0.017 m^2) but no volume, which is necessary for a heat source with a unit of W/m^3. When I try to run the simulation with "Total Power" equal my required 130 W, the result is far away from my analytical one.

I'm thankful for any advice, I'm pretty new at COMSOL and an electrical engineer so I'm not really familiar with themal stuff ;-).

BR

I calculated the cooling of a plate by a turbulent forced convection analytically. Now I want to check my results with COMSOL but I have some troubles, maybe someone would be so kind and help me.

My plate is 0.075 m long, to keep the plate at +4 °C i need a power of ~130 W. The cooling fluid is air and has a temperature of -30 °C with a "inflow" - velocity of 45 m/s.

I tried to model my plate in COMSOL with a rectangle ( 0.075 m x 0.005 m ), this plate is in the upper right corner of an "larger" rectangle. The inlet is on the left. The material of my plate is copper.

My first problem is how to fit the power, because for my analytic approach i have just a surface (~0.017 m^2) but no volume, which is necessary for a heat source with a unit of W/m^3. When I try to run the simulation with "Total Power" equal my required 130 W, the result is far away from my analytical one.

I'm thankful for any advice, I'm pretty new at COMSOL and an electrical engineer so I'm not really familiar with themal stuff ;-).

BR

7 Replies Last Post 17/10/2013, 06:54 GMT-04:00